Set up Wireless for Cisco EPC3928D

  1. Open a Browser and type http://192.168.1.1 in Address bar and then enter Username = admin, Password = password and click Log In
  2. At WPS, click Enable when want to use WPS (connect Wireless by pressing button at router and select WPS at device)
  3. At Wireless > Radio Settings separated into 2 sections: Wi-Fi Radio 1 Network (2.4GHz) and Wi-Fi Radio 2 Network (5GHz) set up as follows:
    • Click Enable Wireless Interface
    • Network Mode : B/G/N Mixed
    • Standard Channel : Auto or Channel that's most free in that area
    • Tick a check at Broadcast SSID
    • Click Save Settings
  4. At Wireless Security separated into 2 sections: Wi-Fi Radio 1 Security (2.4GHz) and Wi-Fi Radio 2 Security (5GHz) It can be set various types as shown but recommend to set as WPA or WPA2 - Personal
  5. At MAC Filter, to use click Enable
    • Select Block to block below MAC Address to access wireless network
    • Select Permit to allow below MAC Address to access wireless network
    • Up to 32 MAC Address can be set up
    • Click Save Settings
  6. At Advance Settings separated into 2 sections: Wi-Fi Radio 1 Settings (2.4GHz) and Wi-Fi Radio 2 Settings (5GHz) and set up as follows:
  7. At WDS Settings separated into 2 sections: Wi-Fi Radio 1 WDS Settings (2.4GHz) and Wi-Fi Radio 2 WDS Settings (5GHz)
    • Tick a check at Allow Wireless Signal..... if want to set, bring MAC Address of other Router Wireless to enter in MAC1 (up to MAC3)
    • Click Save Settings
  8. At QoS, set up as shown
Download File

Was this helpful?

Very bad Very Good

Related topics

Set up IPSec and VPN for Cisco EPC3928D Set IP Gateway for Cisco EPC3928D Allow Remote Config from WAN IP on Cisco EPC3928D Set Parental Control for Cisco EPC3928D Set Password to access Cisco EPC3928D