Set up Wi-Fi on Skyworth GN542VF

  1. Type 192.168.1.1 and press Enter, User = admin, Password = enter letters as shown below and then press Login
  2. Go to Network
  3. At WLAN 2.4G and set up as follows:
    • Enable : enable-disable Wi-Fi network
    • Mode : choose Mode, by default is 802.11b/g/n
    • Channel : choose Wi-Fi channel, by default is Auto
    • SSID : Wi-Fi network name
    • Bandwidth (MHz)  : by default is 20
    • Associate Number : number of connected device, maximum 32 devices
    • SSID Enable : enable-disable Wi-Fi network name
    • RF Output Power : by default is Standard
    • WPS Enable : enable-disable WPS
    • WPS Mode : choose Mode of WPS
    • Security Setting : choose Wi-Fi security type
    • Pre-Shared Key (PSK) : Wi-Fi password
  4. Select WLAN 5G and set up as follows:
    • Enable  : enable-disable Wi-Fi network
    • Mode : choose Mode, by default is 802.11a/n/ac
    • Channel : choose Wi-Fi channel, by default is Auto
    • SSID : Wi-Fi network name
    • Bandwidth (MHz) : by default is 80
    • Associate Number  : number of connected device, maximum 32 devices
    • SSID Enable : enable-disable Wi-Fi network name
    • RF Output Power : by default is Standard
    • WPS Enable : enable-disable WPS
    • WPS Mode : choose Mode of WPS
    • Security Setting : choose Wi-Fi security type
    • Pre-Shared Key (PSK) : Wi-Fi password

Was this helpful?

Very bad Very Good

Related topics

How to solve Problem Skyworth GN542VF setup with True DDNS and IP Camera Set up Skyworth GN542VF to use True DDNS with IP Camera Check Device connected to Skyworth GN542VF Configure Dynamic DNS on Skyworth GN542VF Port Forwarding on Skyworth GN542VF