Wi-Fi Configuration on HUAWEI HG8247W5
Log In Configuration page
- Type 192.168.1.1 then press Enter
- User Name = admin
- Password = enter letters as shown in Default Password
- press Log In
Basic Configuration
- At main page, select Wi-Fi Configuration
- set up as follows:
- Enable 2.4G Network : enable/ disable Wi-Fi 2.4G
- Wi-Fi Name : name Wi-Fi 2.4G (can set new name)
- Password : Wi-Fi password (contains 8 – 63 characters)
- Enable 5G Network : enable/ disable Wi-Fi 5G
- Wi-Fi Name : name Wi-Fi 5G (can set new name)
- Password : Wi-Fi password (contains 8 – 63 characters)
- when finished, press Save
Advanced configuration: Wi-Fi 2.4G
- Go to WLAN
- 2.4G Basic Network Settings
- Enable WLAN : tick a check to enable Wi-Fi, remove a check to disable Wi-Fi
- SSID Name : enter Wi-Fi name (contains 1-32 characters)
- Enable SSID : tick a check to enable this SSID
- Number of Associated Devices :
- Broadcast SSID : tick a check, if want to hide, remove a check
- Authentication Mode : default is WPA / WPA2 PreSharedKey
- Encryption Mode : default is TKIP&AES
- WPA PreSharedKey : set password (contains 8 – 63 characters)
- Enable WPS : enable WPS, to disable it, remove a check
- when finished, press Apply
- 2.4G Advanced Network Settings
- TX Power : adjust the strength of Wi-Fi signal, by default is 100%
- Channel : Automatic, if Router is turned off/ on, Channel will be changed to the best channel, you can manually set the preferred Channel
- Channel Width : add channel width this will add more Sync Speed but the connected device must support 40Mhz
- Mode : select 802.11b/g/n , this parameter is compatible with all types
- when finished, press Apply
Advanced configuration: Wi-Fi 5G
- Go to WLAN
- 5G Basic Network Settings
- Enable WLAN : tick a check to enable Wi-Fi, remove a check to disable Wi-Fi
- SSID Name : enter Wi-Fi name (contains 1-32 characters)
- Enable SSID : tick a check to enable this SSID
- Number of Associated Devices :
- Broadcast SSID : tick a check, if want to hide, remove a check
- Authentication Mode : default is WPA / WPA2 PreSharedKey
- Encryption Mode : default is TKIP&AES
- WPA PreSharedKey : set password (contains 8 – 63 characters)
- Enable WPS : enable WPS, to disable it, remove a check
- when finished, press Apply
- 5G Advanced Network Settings
- TX Power : adjust the strength of Wi-Fi signal, by default is 100%
- Channel : Automatic , if Router is turned off/ on, Channel will be changed to the best channel, you can manually set the preferred Channel
- Channel Width : add channel width this will add more Sync Speed
- Mode : select 802.11a/n/ac , this parameter is compatible with all types
- when finished, press Apply