Set up Wireless for TurboSpeed TCG220-T
Set up 802.11Band และ Channel
- Type 192.168.1.1 then press Enter, type Username = admin , Password = password and press Login
- On top, click Wireless > Radio set up as follows:
- Wireless Interface : choose to set Wireless channel, select Mac Address and at 802.11 band, check to see if it is 2.4GHz or 5GHz
- Wireless : Enabled
- Bandwidth : 2.4GHz should select 20MHz, 5GHz should select 20 or 40MHz
- Control Channel : select Auto but can change it to avoid overlapping with other Wireless Channel by using Scan Wireless APs button
- Press Apply
Set up SSID and Security
- On top, click Wireless > Primary Network set up as follows:
- Primary Network : Enabled
- Network Name (SSID) : enter network name
- Select Enabled at WPA-PSK and WPA2-PSK
- WPA/WPA2 Encryption : AES
- WPA Pre Shared Key : enter the password to use Wireless (click Show Key to see the password typed)
- WPS : choose WPS or Disabled depending on usage. Press WPS button to use Wireless and select WPS
- Scroll bar down to next page
- It is not recommended to set up WEP since it's old Security system, click Apply
Set up MAC Filter
- On top, click Wireless > Access Control > MAC Restrict Mode
- Disabled : do not use this function
- Allow : allow the access only specific MAC Address
- Deny : not allow the access only specific MAC Address
- Enter MAC Address and click Apply, that MAC Address will appear in table
Set up WDS
- On top, click Wireless > Bridging > Wireless Bridging then select Enabled to set up WDS by entering Wireless MAC Address of main Wireless Router (mostly Router should be the same brand and model) then click Apply