Allow Remote Config from WAN IP for ZTE F668

  1. Open a Browser, type http://192.168.1.1 in the Address bar then press Enter, at ZTE page enter Username = admin, Password = password then press Login
  2. Click Security > Service Control and set up as follows:
    • IP Version = IPv4
    • Tick a check mark at Enable
    • Ingress = omci_ipv4_pppoe_1
    • Mode = Permit
    • Tick a check mark at HTTP
    • Press Add
  3. Once completed, information will be shown in a table that means already allowed Remote config on Router from WAN IP

Was this helpful?

Very bad Very Good