Set T3 ST-244F to use with T3 MESH A5258 1 SSID

Set 1 SSID will enhance the most efficiency of MESH’s function, Router and MESH will figure out the proper frequency for the connected device to use 2.4GHz or 5GHz, first priority is 5GHz.

  1. Set up at SERCOM T3 ST-244F by connecting via LAN or Wi-Fi
  2. Open a Browser and type 192.168.1.1 at the Address bar then press Enter. UserName = admin/ Password = enter letters as shown below and press Login
  3. Check Firmware Version, it muse be V3.3.8
  4. Set SSID to be the same for both 5GHz and 2.4GHz
  5. Enter Pre-Share Key to be the same for both 5GHz and 2.4GHz
  6. Enable Function Band Steering 
  7. Set SERCOM T3 ST-224F to be Controller : click WLAN > Easy Mesh > EasyMesh Interface Setup > Role : choose Controller > press Apply Changes
  8. Connect SERCOM T3 ST-244F and SERCOM T3 MESH A5258 > by connecting LAN cable into LAN port of SERCOM T3 ST-244F and WAN port of SERCOM T3 MESH A5258
  9. Wait until LED changed from red to blue around 1 minute
  10. Place SERCOM T3 MESH A5258 at preferred location. Router and MESH will send-receive wireless signal and they should be placed at the suitable distance. If MESH can’t receive signal from the starting device, it may result the usage efficiency
Download File

Was this helpful?

Very bad Very Good