Set up Wi-Fi on HUAWEI DN8245W

  1. Type 192.168.1.1 at Browser and press Enter, User = user, Password = HuaweiUser then press Log In
  2. Basic Configuration
    • Click Home Page > Wi-Fi configuration
    • Wi-Fi settings
      • Enable 2.4G / 5G Network : button to enable/ disable Wi-Fi signal
      • Wi-Fi Name : Wi-Fi name (can reset)
      • Password : password must contain 8 – 63 characters)
      • Once completed, press Save
  3. Advanced Configuration
  4. Wi-Fi 2.4G
    1. Basic Configuration Wi-Fi 2.4G
      1. Click Advanced Configuration > WLAN > 2.4G Basic Network Settings
      2. Wi-Fi name and other settings
        • Enable WLAN : click a check to enable Wi-Fi,  remove a check to disable
        • SSID Name : enter Wi-Fi name (1-32 characters)
        • Enable SSID : click a check mark
        • Broadcast SSID : click a check mark, if want to hide network name, remove a check mark
        • Once completed, press Apply
      3. Set password for Wi-Fi 2.4G : WPA / WPA2 / WPA/WPA2 PreSharedKey, Open, Shared (WEP)
    2. Advanced Configuration Wi-Fi 2.4G
      1. Click Advanced Configuration > WLAN > 2.4G Advanced Network Settings
      2. Advanced Configuration
        • TX Power : adjust Wi-Fi network strength, by default is 100%
        • Channel : Automatic , if Router is turned off/ on, the channel will be changed to the best channel at that moment, can manually set by choosing the preferred Channel
        • Channel Width : add channel width that will increase Sync Speed but the connected device must support 40Mhz so it can work
        • Mode : choose 802.11b/g/n , this parameter supports all types
        • Once completed, press Apply
  5. Wi-Fi 5G
    1. Basic Configuration Wi-Fi 5G
      1. Click Advanced Configuration > WLAN > 5G Basic Network Settings
      2. Wi-Fi name and other settings
        • Enable WLAN : click a check to enable Wi-Fi,  remove a check to disable
        • SSID Name : enter Wi-Fi name (1-32 characters)
        • Enable SSID : click a check mark
        • Broadcast SSID : click a check mark, if want to hide network name, remove a check mark
        • Once completed, press Apply
      3. Set password for Wi-Fi 5 : WPA / WPA2 / WPA/WPA2 PreSharedKey, Open, Shared (WEP)
    2. Advanced Configuration Wi-Fi 5G
      1. Click Advanced Configuration > WLAN > 5G Advanced Network Settings
      2. Advanced Configuration
        • TX Power : adjust Wi-Fi network strength, by default is 100%
        • Channel : Automatic , if Router is turned off/ on, the channel will be changed to the best channel at that moment, can manually set by choosing the preferred Channel
        • Channel Width : add channel width that will increase Sync Speed
        • Mode : choose 802.11a/n/ac, this parameter supports all types
        • Once completed, press Apply

Was this helpful?

Very bad Very Good