Check Signal Status and Search Channel on OPENTEL 4K-OP10C

  1. Press MENU button on remote control
  2. Press "Down" arrow to (System Setting) and press OK on remote control
  3. Press "Down" arrow to (System Setting) and press OK on remote control
  4. Select (CHANNEL SEARCH) and press OK on remote control
  5. Set CHANNEL SEARCH as follows:
    • Frequency: choose 306 MHz
    • Network Search: choose Auto Search
  6. When finished, press "Right" arrow to (CHANNEL SEARCH) and press OK on remote control
  7. System is searching for channel
  8. Press "Right" arrow to (Start Service) and press OK on remote control

Was this helpful?

Very bad Very Good

Related topics

Reset Factory Setting on OPENTEL 4K-OP10C Upgrade Software on OPENTEL 4K-OP10C Check and Remove Reminder on OPENTEL 4K-OP10C Set Reminder Channel on OPENTEL 4K-OP10C Set Audio Language and Audio Output on OPENTEL 4K-OP10C